View this page for 
| 
| 
The protection policy defines the protection requirements for a provisioned object (Transaction Signing Key, Session Transport Key, or OTP Key).
The ProtectionPolicyType values are:
- Device – the object is protected against cloning (that is, it cannot be used outside the mobile device).
- Password – the object is also protected by an end-user password.
For further details, see:
ActivID AS push solution customization
ActivID Appliance push solution customization
HID Authentication Service push solution customization
PasswordPolicy
This policy defines the constraints on the password protecting the object:
- Minlength – Minimum password length
- Maxlength – Maximum password length
- Additional restrictions for alphanumeric format:
- Min Number of UpperCase letters
- Min Number of LowerCase letters
- Min Number of Alpha characters
- Min Number of Numeric characters
- Min Number of Non-Alphanumeric characters
- Maximum Number of UpperCase letters
- Maximum Number of LowerCase letters
- Maximum Number of Alpha characters
- Maximum Number of Numeric characters
- Maximum Number of Non-Alphanumeric characters
- History restriction parameters:
- maxHistory – number of unique new passwords that have to be associated with the key before an old password can be reused. 0 authorizes users to reuse current password when password is changed. This value is set by the server.
- minAge – period of time (in days) that a password must be used before the user can change it. It must be less than the maximum password age. 0 allow changes immediately. This value is set by the server. Note: When >0, the initial password must be changed at the end of the provisioning for the minAge parameter to be taken into account.
- maxAge – period of time (in days) users can keep a password before they have to change it. 0 means password never expires. This value is set by the server.
When defining the rules of the password policy, make sure that there are no logical conflicts. For example, do not specify that the minimum number of numeric characters is 8, in combination a maximum password length of 6 characters.
When not set, the maximum values are equal to the maximum length defined for the password.
Using a PIN or Numeric Password
You can define an exclusive numeric (PIN) policy which is more user-friendly in mobile authentication deployments.
As an example, the following parameters can be used to set a numeric-only policy for a 6 to 10-character password length:
- MinLength = 6
- MaxLength = 10
- MinNumeric = 6
- MaxNumeric = 10
- maxUpperCase = 0
- maxLowerCase = 0
- maxAlpha = 0
- maxNonAlpha = 0
In the server configuration, this would be defined with the following key protection policy parameters:
UP=0;LOW=0;NUM=6;ALPHA=0;NALPHA=0;MUP=0;MLOW=0;MNUM=8;MALPHA=0;MNALPHA=0;MINLEN=6;MAXLEN=8
For further details, see:
ActivID AS Key Protection Policy Parameters
Lock Policy
The following sections define the LockType type and parameters for the password and lock.
Type
- None – password never locks.
- Lock – password locks after maximum counter value is reached.
- Delay – an exponential delay is inserted between each failed authentication attempt.
Parameters
- initialDelay – initial delay value in seconds (in delayLock type).
- maxCounterValue – maximum counter value after which exponential delay is fixed in delayLock type, or maximum counter value after which no more authentication attempts are allowed in counterLock type.
For further details, see:
ActivID AS Key Protection Policy Parameters
